£27.50
Specially designed for a perfect fit inside a Lucas 679 rear lamp unit, this 12v LED array features tail, brake and numberplate illumination using an array of super-bright wide-angle red and white LEDs.
This version of our LED light board to fit Lucas 679 rear light units is currently in production and will be available soon.
This fantastic new LED light board has been specially designed to fit perfectly inside the red outer lens of a Lucas 679 rear motorcycle lamp as fitted to countless classic motorcycles from the 1950’s onwards. It replaces the standard filament bulb giving a huge reduction in power consumption, increased reliability and improved visibility.
| Connector options available: | A choice of electrical connector options are available as follows: – Three-wire connector (included as standard) – BAY15D bulb adapter (optional upgrade) – BA15D bulb adapter (optional upgrade) – BA15S bulb adapter (optional upgrade) |
|---|---|
| Voltage: | The operating voltage range of the LED light board is as follows: – 12.0v nominal (12.6v for lead acid battery) – 10.7v minimum (for full brightness) – 18.0v maximum |
| Current: | Approximate values measured at 12.0v: – 80mA for the brake light – 60ma for the tail and numberplate lights – 140mA for the brake, tail and numberplate lights |
| Power: | The power consumption of the LED light board operating at 12.0v is: – 0.96W for the brake light – 0.72W for the tail and numberplate lights – 1.68W for the brake, tail and numberplate lights |
| Number of LED's: | 4x super-bright red LEDs for tail light function 6x super-bright red LEDs for brake light function 3x super-bright white LEDs for number plate illumination |
| Polarity: | Positive or negative earth (automatically corrects polarity) |
| Size: | Designed to fit perfectly inside a Lucas 564 rear light unit: – Width: 80mm – Height: 40mm – Thickness: 16mm |
| Weight: | Approximately 14 grams (excluding wiring and fixings) |
| Also included with the LED light board: | The following accessories are also included with the LED light board: – 1x wiring harness with bare terminals (or optional adapter) – 2x mounting posts – 2x M3 mounting screws – 2x M3 mounting nuts – 2x insulating washers – 4x M3 spring locking washers |
| Further questions? | If you have any further questions, please use the contact form at the bottom of the page to get in touch with me and I willll do my best to respond quickly with an answer. |
Reviews
There are no reviews yet.